Iwill KK266plus Review by Dean

August 29, 2001

Page 1: Introduction
Page 2: Board Layout
Page 3: Overclocking and Test System
Page 4: 3D Benchmarks
Page 5: More Benchmarks and Final Words

Benchmarks Continued

Sysmark2000 now seems to be pretty much limited by the hard disk drive. The difference of the overclocked KK266plus isn't really far but this time around, a small difference could mean a good amount of time. While I did not really record exact times, the KK266plus running at 164MHz fsb ran benchmarks that are not too hard drive dependent faster.

Same here...same performance at the same settings.

Final Words

The KK266plus is definitely another winner. Iwill maintained the same level or even improved the overclockability and stability of the motherboard and made it even better. Again, the primary selling point of the KK266plus series is the onboard sound because it is that which really makes the KK266 and KK266plus different from one another. Buying a KK266plus to replace your KK266 isn't really a good idea since the offer the same performance at the most tweaked settings. If you already have a good sound card, there's no more reason to go for the KK266plus unless you want to use the onboard sound chip. Onboard sound is now better than ever and being able to make a cheap but great system is now so easy. For a low price, you get a highly-overclockable KT133A motherboard, RAID (for KK266plus-R) and even a kickass onboard hardware sound solution.

The only drawback here is the same level of performance with the KK266. It would've really be nice if the KK266plus performed significantly faster than the KK266 at their same most tweaked settings. It would also be fun if Iwill totally eliminated the jumpers on the motherboard in place of a totally jumperless setup. The layout's only drawback was the placement of the power connector but that's just something very minor.

Now the question is: Is it still worth buying a KT133A when the DDR boards are already out? If you're starting from an old system and would want to re-use old PC133 memory, then a KT133A is definetely an option but if you're starting from scratch, it would be better to go DDR though not yet because we've yet to see the other DDR chipsets that are coming out and possibly from all of them, decide which one to get.

Take me home


Relax, Trudy owns j00.